hi
i downloaded the trial and i have set up pokerstars and ladbrokes(i poker) seemingly ok. however i can't get party poker past the press F10 to fold stage- it just doesn't happen. i have changed the poker client software settings as in your guide so i'd appreciate some help to get it sorted
thanks
I am having the same issue.
Fixed with the last version!
TY
thanks seems to be ok now
i started new thread because i wasn't sure if this was a purely setup problem or not
its all good.. let me know if you notice anything that doesn't work
hi
i now have a problem on pokerstars where the tables do not stack. it still works on the very first 4 table configuration i made but not on 6 table configurations although it did before. i tried creating a new one but that didn't work either
the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396?
(02-27-2018, 01:19 AM)Hacksaw Hal Wrote: [ -> ]hi
i now have a problem on pokerstars where the tables do not stack. it still works on the very first 4 table configuration i made but not on 6 table configurations although it did before. i tried creating a new one but that didn't work either
(02-27-2018, 01:35 AM)Hacksaw Hal Wrote: [ -> ]the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396?
I would think it should work at that table size. But the problem is that SaT is not detecting when it is your turn to act. There can be a few different reasons for this. I'd run this Test and maybe try Removing and re-Including the site:
http://www.stackandtile.com/sat/help/tab...ncorrectly
Worst case is you can try creating a File->New Layout, and resizing a Stars table
with your mouse slightly larger than 536x396, and then pressing F7 during the New Layout wizard. And then see if it works in this new layout with a slightly larger slot size
thanks. everything working ok again now