Post a New Reply
Reply to thread: layout creation issue
Username:
Please select the number: 9	1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message: Smilies	[quote="DS1" pid='6619' dateline='1456918594'] That works thanks :) [/quote]
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Image Verification Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.	(case insensitive)

Thread Review (Newest First)

Posted by DS1 - 03-02-2016, 09:36 PM

That works thanks

Posted by SaT_Admin - 02-24-2016, 11:33 PM

Yeah exactly, it was for convenience. I did make a way to override it, but I may have forgotten it off the top of my head. Try holding down CTRL while you drag and drop and see if that cancels the snap

Posted by DS1 - 02-24-2016, 09:26 PM

Ok so when I go to 'visualize grid' and try to adjust the tables. I have noticed that there is a 'snap to' action enabled with moving the tables.    Basically if I move slot 1 next to slot 2 and drop it, slot 1 will snap to a position that lines up with slot 2 nicely, however not exactly where I released the mouse button.  This is probably usually a convenience to people  looking to do a normal grid. I was wondering if I could turn this off so that I can make a cascaded grid with VERY slight cascades leaving just enough room for my "move mouse to x/y" to place the mouse in the lower left of each screen without being covered by another window. I would like to get like 36 tables in this one screen cascaded and absolutely need to have the 'snap to' turned off to do it. Thanks for your help.