StackAndTile Forums › General › Support Help › on top of all windows
Post Reply

Post a New Reply
Reply to thread: on top of all windows
Username:
Please select the number: 3
1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message:
Smilies
Angel Angry Blush Confused
Dodgy Exclamation Heart Huh
Idea Sleepy Undecided Smile
Wink Cool Big Grin Tongue
Rolleyes Shy Sad  
Post Options:
Thread Subscription:
Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)



Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)


Thread Review (Newest First)
Posted by SaT_Admin - 04-19-2016, 06:27 AM
(04-19-2016, 03:35 AM)Mariooooo Wrote: Thanks, I solved the problem! But the question remains, can be done so that the table after the hand (but not when you press the fold) is returned to the stack? And it turns out that the program pulls my active table into a cell, where the distribution is over and he is still there and returned only by pressing the hotkey, can be done automatically?

Normally, the tables will only go back to the stack when you click Fold with your mouse, or when you use a "Stack" hotkey, such as "Fold+Stack".

The only other times that would happen is when you either 1. go to showdown, or 2. you bet and everyone else folds. In both of those cases, a new hand is going to start within a few seconds, and you will have a new decision. So there isn't much benefit for the table to automatically to go back to the stack.

However, if you really want this, you can go to Advanced Options and find the setting to "Stack Table at End of Hand". If you turn this on, then you will need to Remove and re-Include your sites, and you will also need to make sure you are using preferred seating so that you are always sitting in the same place.
Posted by Mariooooo - 04-19-2016, 05:31 AM
With this understood, too)
Posted by Mariooooo - 04-19-2016, 03:35 AM
Thanks, I solved the problem! But the question remains, can be done so that the table after the hand (but not when you press the fold) is returned to the stack? And it turns out that the program pulls my active table into a cell, where the distribution is over and he is still there and returned only by pressing the hotkey, can be done automatically?
Posted by SaT_Admin - 04-18-2016, 10:58 PM
What site is sticking to the top? You need to check each site and figure out where the problem is. Follow this Test:
http://www.stackandtile.com/sat/help/tab...ncorrectly

Then we can go from there
Posted by Mariooooo - 04-18-2016, 10:38 PM
Hello! I have a problem with tables stack does not behave correctly, some of the tables are starting to be on top of all windows and even action on the other tables are on top of all windows, saves only the movement of the table, it happens very often, and it is impossible to play comfortably