Post a New Reply
Reply to thread: I need help return table at slot.
Username:
Please select the number: 2	1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message: Smilies	[quote="SaT_Admin" pid='1481' dateline='1356903502'] You have to turn on the two settings above in Advanced Options first. [/quote]
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Image Verification Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.	(case insensitive)

Thread Review (Newest First)

Posted by SaT_Admin - 12-31-2012, 08:46 AM

Yes that's correct.

Posted by dariovillar - 12-31-2012, 08:16 AM

Ok Ready. Step1, in About, click on advanced Options Step2, Send tables to stack at end of hand Step3, Include holecard detection Step4, cards at pokerstars white. Than you for the help. Now test with 35 tables. Will write my experience.

Posted by SaT_Admin - 12-31-2012, 07:38 AM

You have to turn on the two settings above in Advanced Options first.

Posted by dariovillar - 12-31-2012, 07:28 AM

Ok but when I config the new site, no option hole card detection. Only press F9 for detect and F10 por fold card. Other way? Than you for the help

Posted by SaT_Admin - 12-31-2012, 06:54 AM

What do you mean by "when the action is finished"? Do you mean when the hand is finished? If so, then you want to turn on "Stack Table at End of Hand" and probably "Include Hole Card Detection" http://www.stackandtile.com/sat/help/advanced-options Turn those on, and then you will have to remove and re-Include your Sites

Posted by dariovillar - 12-31-2012, 05:15 AM

The problem is when action finish, the table dont return the stack, need i click on "Fold Zone". ¿Any solution? Than you

Posted by SaT_Admin - 12-31-2012, 05:04 AM

'Move To Grid' setting = After Entering Pot

Posted by dariovillar - 12-31-2012, 04:50 AM

Sorry if the question is doing, but to me is impossible read in english. Sorry for my english, iam spanish man. Only want that a table is on pot, (VPIP), call, check or bet, the table go a new slot and when the action finish, the table return the stack. Is possible this with S&T? Thank you for the help, and again, sorry for my english.