| Thread Review (Newest First) |
| Posted by SaT_Admin - 01-10-2013, 12:49 PM |
(01-10-2013, 12:24 PM)hankwhite Wrote: there is no preferred seating on BCP.could that be a problem? i do move to the same seat on every table though.I do play 6 and 9 handed and thers a slight diff in seating positions between the 2. Yes this will likely cause a problem. I would enable all the Notifications in Advanced Options and look for any popups that might give you clues as to what is happening. Quote:Stay in the grid even after i fold or win and the hand is over.It will stay there until im dealt a new hand. These two are very different. You need to be certain which is causing the problem. Clicking fold or using a fold hotkey should always send the table back to the stack. If that isn't working, then we have some different problems. Quote:Im sure it works because it works about 90% of the time until it leaves a table in my grid after the hand is over and im dealt a new hand Well, you can work around this by using a 'Stack Table' hotkey. Although for me it was never personally a problem because a new hand is starting and in a few seconds I will have to make another decision on that table anyway. |
| Posted by hankwhite - 01-10-2013, 12:24 PM |
|
there is no preferred seating on BCP.could that be a problem? i do move to the same seat on every table though.I do play 6 and 9 handed and thers a slight diff in seating positions between the 2. "Sometimes will stay in the grid 'even after' what?" Stay in the grid even after i fold or win and the hand is over.It will stay there until im dealt a new hand. ""Are you sure that End Of Hand detection is working properly? Are you using preferred seating? "" Im sure it works because it works about 90% of the time until it leaves a table in my grid after the hand is over and im dealt a new hand |
| Posted by SaT_Admin - 01-10-2013, 11:44 AM |
(01-10-2013, 10:46 AM)Guest Wrote:(01-10-2013, 10:39 AM)Guest Wrote: just noticed "activate_most_urgent=0" if i make this "1" will the windows pop up in highlighted in the order i need to act? Not sure what you mean. Why did you uncheck it? Its the first setting in the Advanced Options menu. (01-10-2013, 10:38 AM)Guest Wrote: Anyway my problem is (when im on BCP)u can see from my config i have 12 slots and use the S&T function w/VPIP.When i play a hand it will bring the table out to the next avail slot and do this for each table i VPIP.Problem is sometimes EVEN AFTER it will stay in the grid(same slot it was in) and sometimes it will go back to the stack. Sometimes will stay in the grid 'even after' what? Quote:ALSO sometimes if i time down and sit out by mistake its impossible to get to the table to sit back in without disabling the program beacause i play so many tables theres always an active one. SaT will not force a table to be active if you try to change focus. For example, if some table requires action, and SaT activates it (if the setting is on), and then later you click away to another table, SaT will not force activation again until you've acted somewhere. Quote:BIG problem for me though when the hand ends and stays in the slot because i overlap 4 spots and need to clear out the unused spot asap so i can see all thats going on. Are you sure that End Of Hand detection is working properly? Are you using preferred seating? Would using a 'Stack Table' hotkey be sufficient to clear a table? |
| Posted by - 01-10-2013, 10:46 AM |
(01-10-2013, 10:39 AM)Guest Wrote: just noticed "activate_most_urgent=0" if i make this "1" will the windows pop up in highlighted in the order i need to act?  actually i have this clicked and it was a prob thats why i unticked it. |
| Posted by - 01-10-2013, 10:43 AM |
| Maybe it could be my "end of hand stack delay"?? ill try to make this 0.i may be getting cards too fast for the prog to realize the hand is over |
| Posted by - 01-10-2013, 10:39 AM |
| just noticed "activate_most_urgent=0" if i make this "1" will the windows pop up in highlighted in the order i need to act? |
| Posted by - 01-10-2013, 10:38 AM |
|
[settings] table_width=933 table_height=694 total_slots=12 slot1x=960 slot1y=356 slot2x=27 slot2y=356 slot3x=960 slot3y=0 slot4x=27 slot4y=0 stack_slot=1 newtables_slot=1 move_on_street=preflop oldtables_duration=4 oldtables_slot=12 scan_mode=DWM activate_most_urgent=0 highlight_active_win=1 move_mouse_to_most_urgent=0 left_click_detection=1 stack_table_at_end_of_hand=1 send_to_bottom_on_stack=1 end_of_hand_restack_delay=1000 highlight_border_size=7 highlight_border_color=FFFF00 check_holecard_for_end_of_hand=1 drag_drop_swap_slots=1 minimize_to_tray=1 show_table_count_while_running=1 notify_new_tables=1 notify_old_tables=1 notify_keep_in_grid=1 notify_ignore_table=1 notify_action_required=0 notify_end_of_hand=0 notification_duration=7 move_to_grid=vpip play_mode=SaT slot5x=0 slot5y=356 slot6x=933 slot6y=0 slot7x=0 slot7y=0 table_count_gui_x=1951 table_count_gui_y=1080 slot8x=0 slot8y=358 slot9x=961 slot9y=0 slot10x=26 slot10y=0 slot11x=28 slot11y=356 slot12x=1920 slot12y=0 [general] show_walkthru=0 gui_x=-32000 gui_y=-32000 last_tab= is_reloading=1 version=2.2.0.2 v=fu [sites] number_of_sites=1 included_sites=WinningPoker WinningPoker_included_executable_path=C:\BlackChipPoker\BlackChipPoker.exe WinningPoker_included_resized_table_width=933 WinningPoker_included_resized_table_height=694 WinningPoker_included_hole_x_coord=444 WinningPoker_included_hole_y_coord=454 WinningPoker_included_fold_color=0xaf5b1d WinningPoker_included_call_color=0xc56a1f WinningPoker_included_bet_color=0xc56a1f WinningPoker_included_table_color_behind_holecard=0x60606 WinningPoker_included_flop_x_coord=376 WinningPoker_included_flop_y_coord=244 WinningPoker_included_table_color_behind_flop=0x121212 [hotkeys] number_of_hotkeys=9 hotkey1action=Bet hotkey1key=XButton2 hotkey2action=Call hotkey2key=MButton hotkey3action=Fold + Stack table hotkey3key=XButton1 hotkey4action=Stack table hotkey4key=ctrl hotkey5action=Move table to Next slot hotkey5key=M hotkey6action=Send table to bottom hotkey6key=B hotkey7action=Keep table in grid hotkey7key=K hotkey8action=Stack all tables hotkey8key=S hotkey9action=Start/Stop SaT hotkey9key=` send_table_under_mouse=1 GOOD IDEA PASTING THE CONFIG  Anyway my problem is (when im on BCP)u can see from my config i have 12 slots and use the S&T function w/VPIP.When i play a hand it will bring the table out to the next avail slot and do this for each table i VPIP.Problem is sometimes EVEN AFTER it will stay in the grid(same slot it was in) and sometimes it will go back to the stack. ALSO sometimes if i time down and sit out by mistake its impossible to get to the table to sit back in without disabling the program beacause i play so many tables theres always an active one. BIG problem for me though when the hand ends and stays in the slot because i overlap 4 spots and need to clear out the unused spot asap so i can see all thats going on. |
| Posted by SaT_Admin - 01-10-2013, 07:44 AM |
| Ok I'll see if I can find anything about this |
| Posted by ThinkTwice - 01-10-2013, 07:43 AM |
| Yes, I turned it on in the new layout.ini, but didn't get any notifications. |
| Posted by SaT_Admin - 01-10-2013, 07:30 AM |
|
Hrm ok. Did you turn on the End Of Hand Notification in Advanced Options? Cause you had it off before.. Anyways, I will try to see if I can reproduce your error. I have been testing all the stuff with Black theme lately and never ran into this. |
| This thread has more than 10 replies. Read the whole thread. |