Post a New Reply
Reply to thread: removing a table from stack and grid
Username:
Please select the number: 6	1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message: Smilies
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Image Verification Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.	(case insensitive)

Thread Review (Newest First)

Posted by thecooler992 - 03-10-2013, 05:29 PM

Thanks for the quick response and that should work perfect

Posted by SaT_Admin - 03-10-2013, 02:07 PM

Two options 1. Use a hotkey to "Keep table in grid". This will keep the table locked in grid and never move back to the stack until you use the hotkey again to toggle it off. The table will ignore any Fold clicks as well as any "Stack" hotkeys. This hotkey was designed for 'special' tables such as MTT Final Tables or HU games. 2. Use a hotkey to "Ignore Table". This will completely remove a table from SaT detection altogether until you press this hotkey again to un-ignore.

Posted by thecooler992 - 03-10-2013, 02:04 PM

Just as the title of this thread suggests that is my issue. I hate when I am deep or short in an mtt n my table is just in the stack like all of my other tables. Is there a way to exclude a table from the grid and stack? If so is it also possible to put the table back in the grid and or stack? Thanks