Post a New Reply
Reply to thread: 1/4 1/2 pot buttons on microgaming
Username:
Please select the number: 2	1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message: Smilies
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Image Verification Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.	(case insensitive)

Thread Review (Newest First)

Posted by SaT_Admin - 09-01-2013, 06:06 AM

Great to hear

Posted by - 09-01-2013, 04:39 AM

Well done.Ty -it works ok)

Posted by SaT_Admin - 09-01-2013, 02:12 AM

My apologies. This is a bug and is fixed in the latest version 2.4.05. The problem was that I was not actually reading those lines from the file. However, if those lines are disappearing from your file, then there is definitely something else going wrong..

Posted by SaT_Admin - 08-31-2013, 11:20 AM

You're doing something wrong then. Maybe you put those lines in the wrong file. They need to go in the micrograming custom .ini file. Those lines do not go in your SaT Layout file.

Posted by - 08-31-2013, 10:21 AM

dont work: lines betsize1_x_coord= and betsize1_y_coord= disappears after launch SaT

Posted by SaT_Admin - 08-29-2013, 12:58 AM

Yes you can, but it will require some editing of your micgrogaming custom ini file. See this page: http://www.stackandtile.com/sat/help/bet-size-hotkeys Specifically you will need to add the x/y coordinates for each of those 5 buttons. First you will need to make sure that the table is the same size as the standard_table_width and standard_table_height settings at the top of the file. Then, with the table that size, you will need to grab the x/y coordinates of each of those buttons. Then add new lines to the file named betsize1_x_coord= and betsize1_y_coord=

Posted by zah11 - 08-28-2013, 10:47 PM

Hi can i set the hotkeys on it? [img][/img]