Post a New Reply
Reply to thread: how to delay moving to grid
Username:
Please select the number: 1	1 2 3 4 5 6 7 8 9 10
Post Subject:
Your Message: Smilies	[quote="SaT_Admin" pid='3348' dateline='1390756319'] [c]engine_delay[/c] has different default values depending upon the Scan Mode, but it too is in milliseconds. You don't want to this number to be too low. You should probably always keep it at 300 or over. You can set it to 1000 or higher and see if that gives you the delay you want. [/quote]
Post Options:	Disable Smilies: disable smilies from showing in this post.
Thread Subscription: Specify the type of notification and thread subscription you'd like to have to this thread. (Registered users only)	Do not subscribe to this thread Subscribe without receiving any notification of new replies Subscribe and receive email notification of new replies Subscribe and receive PM notification of new replies
Image Verification Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.	(case insensitive)

Thread Review (Newest First)

Posted by SaT_Admin - 01-27-2014, 03:11 AM

engine_delay has different default values depending upon the Scan Mode, but it too is in milliseconds. You don't want to this number to be too low. You should probably always keep it at 300 or over. You can set it to 1000 or higher and see if that gives you the delay you want.

Posted by bushiur - 01-26-2014, 08:30 AM

Thanks a lot, engine_delay is what I am looking for

Posted by SaT_Admin - 01-26-2014, 03:17 AM

In the past, there were two timing settings in advanced options. One was Engine Delay which controls how often SaT scans the tables and the other was Action Delay which pauses briefly before sending a table to the stack or grid. I believe the second one is what you are talking about. I removed it from the interface because I didn't think many people were actually using it, and also because it is not consistently applied throughout the software. Mostly the Action Delay is used within hotkey actions, when moving a table to the stack or to the grid via hotkey, or via clicks when using Left Mouse Click Detection. However, during the automatic movement of tables into the grid via the 'Move To Grid' setting, the Action Delay doesn't take effect. The ini setting is action_delay and it is in milliseconds. The default value is 150 which would be 0.15 seconds. You can follow the instructions on the Extra Advanced Options help page to add it in.

Posted by bushiur - 01-25-2014, 10:41 PM

In an earlier version about 2 years ago, I was able to set the refreshing rate when a table jumps into the grid in seconds at advanced tab, it was pretty cool, cause know its too fast, I guess is like 0,5sec and got problems with it, because stealing focus too often, I have tried deselecting activate table option in advanced options, but no success. I was looked inside the ini file, but cannot see that setting, what I seen in the earlier version. Can You help?