+- StackAndTile Forums (https://www.stackandtile.com/forum)
+-- Forum: General (https://www.stackandtile.com/forum/forumdisplay.php?fid=1)
+--- Forum: Support Help (https://www.stackandtile.com/forum/forumdisplay.php?fid=2)
+--- Thread: layout creation issue (/showthread.php?tid=1258)
layout creation issue - DS1 - 02-24-2016
Ok so when I go to 'visualize grid' and try to adjust the tables. I have noticed that there is a 'snap to' action enabled with moving the tables. Basically if I move slot 1 next to slot 2 and drop it, slot 1 will snap to a position that lines up with slot 2 nicely, however not exactly where I released the mouse button. This is probably usually a convenience to people looking to do a normal grid.
I was wondering if I could turn this off so that I can make a cascaded grid with VERY slight cascades leaving just enough room for my "move mouse to x/y" to place the mouse in the lower left of each screen without being covered by another window. I would like to get like 36 tables in this one screen cascaded and absolutely need to have the 'snap to' turned off to do it.
Thanks for your help.
RE: layout creation issue - SaT_Admin - 02-24-2016
Yeah exactly, it was for convenience. I did make a way to override it, but I may have forgotten it off the top of my head. Try holding down CTRL while you drag and drop and see if that cancels the snap
RE: layout creation issue - DS1 - 03-02-2016
That works thanks
