1/4 1/2 pot buttons on microgaming - Printable Version +- StackAndTile Forums (https://www.stackandtile.com/forum) +-- Forum: General (https://www.stackandtile.com/forum/forumdisplay.php?fid=1) +--- Forum: Support Help (https://www.stackandtile.com/forum/forumdisplay.php?fid=2) +--- Thread: 1/4 1/2 pot buttons on microgaming (/showthread.php?tid=593)

1/4 1/2 pot buttons on microgaming - zah11 - 08-28-2013 Hi can i set the hotkeys on it? [img][/img] RE: 1/4 1/2 pot buttons on microgaming - SaT_Admin - 08-29-2013 Yes you can, but it will require some editing of your micgrogaming custom ini file. See this page: http://www.stackandtile.com/sat/help/bet-size-hotkeys Specifically you will need to add the x/y coordinates for each of those 5 buttons. First you will need to make sure that the table is the same size as the standard_table_width and standard_table_height settings at the top of the file. Then, with the table that size, you will need to grab the x/y coordinates of each of those buttons. Then add new lines to the file named betsize1_x_coord= and betsize1_y_coord= RE: 1/4 1/2 pot buttons on microgaming - Guest - 08-31-2013 dont work: lines betsize1_x_coord= and betsize1_y_coord= disappears after launch SaT RE: 1/4 1/2 pot buttons on microgaming - SaT_Admin - 08-31-2013 You're doing something wrong then. Maybe you put those lines in the wrong file. They need to go in the micrograming custom .ini file. Those lines do not go in your SaT Layout file. RE: 1/4 1/2 pot buttons on microgaming - SaT_Admin - 09-01-2013 My apologies. This is a bug and is fixed in the latest version 2.4.05. The problem was that I was not actually reading those lines from the file. However, if those lines are disappearing from your file, then there is definitely something else going wrong.. RE: 1/4 1/2 pot buttons on microgaming - Guest - 09-01-2013 Well done.Ty -it works ok) RE: 1/4 1/2 pot buttons on microgaming - SaT_Admin - 09-01-2013 Great to hear