:idea: Help me to setup the optimal config for my use case

[SaT_Admin]

The FAILURE RESIZING errors pretty much stopped.

Thats good at least

The lags got a bit better but still very bad with more than 20 tables.

I turned on the dGPU but didnt improved that much as I thought.

I noticed another issue which is pretty annoying and might be even the reason:
My tables jump to the grid without any action required very freqently!
Why is that?

Well this can happen for a few different reasons, but basically it means that SaT is thinking the fold/call/bet buttons are visible on the table. This could be because the wrong colors were grabbed during Include Site setup, or it could be because SaT is having problems scanning the site.

What site does it happen on? All sites? Only a particular site?

You can run this Test and try to figure out when/why it might be happening, and there are some solutions to try too:

https://www.stackandtile.com/sat/help/ta...ncorrectly

But, this problem shouldn't contribute to the lag I wouldn't think