StackAndTile Forums › General › Support Help
Table stack and back to grid - problem with stack slot?

New Reply 
Linear Mode
Table stack and back to grid - problem with stack slot?
SaT_Admin Offline
'greg nice' on 2p2
*******
Posts: 5,771
Threads: 30
Joined: Apr 2011
#8
08-03-2019, 09:01 AM
Well maybe first try with Party normally, without doing solution #2 changing the DPI setting, and see if it works in SaT. Maybe it will work. If not, then you need to try something else.

Going to 100% will probably be too small. Maybe try 125% and see if you like that. And then Remove and re-Include the sites
Find
Reply
New Reply 


[-]
Quick Reply
Message
Type your reply to this message here.
Username::
Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)
Please select the number: 2
1 2 3 4 5 6 7 8 9 10

Messages In This Thread
Table stack and back to grid - problem with stack slot? - by malejajakoczkodana - 08-03-2019, 06:41 AM
RE: Table stack and back to grid - problem with stack slot? - by malejajakoczkodana - 08-03-2019, 07:19 AM
RE: Table stack and back to grid - problem with stack slot? - by malejajakoczkodana - 08-03-2019, 07:42 AM
RE: Table stack and back to grid - problem with stack slot? - by malejajakoczkodana - 08-03-2019, 08:25 AM
RE: Table stack and back to grid - problem with stack slot? - by SaT_Admin - 08-03-2019, 09:01 AM