StackAndTile Forums › General › Support Help
Switch

New Reply 
Linear Mode
Switch
s pion
Unregistered
 
#1
12-12-2020, 12:21 PM
Hi. Where in the options can I set that it stops that if I am occasionally on a table and there an action perform it switch and comes over another table. If you do not understand what I mean I have to formulate it better.
Reply
New Reply 


[-]
Quick Reply
Message
Type your reply to this message here.
Username::
Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)
Please select the number: 1
1 2 3 4 5 6 7 8 9 10

Messages In This Thread
Switch - by s pion - 12-12-2020, 12:21 PM
RE: Switch - by SaT_Admin - 12-12-2020, 12:30 PM
RE: Switch - by s pion - 12-12-2020, 12:45 PM
RE: Switch - by s pion - 12-12-2020, 12:48 PM
RE: Switch - by SaT_Admin - 12-12-2020, 01:01 PM
RE: Switch - by s pion - 12-12-2020, 01:09 PM
RE: Switch - by SaT_Admin - 12-12-2020, 01:18 PM