01-05-2015, 02:09 AM
Yeah, unfortunately, the way Windows works, once you minimize a table, SaT can no longer scan it properly. So you shouldn't minimize it. This same problem happens on other softwares too, not only SaT.
Another solution for your problem is to use the hotkey to "Send table to bottom". This will move the top table to the bottom of the stack, allowing you to see the previous table. You can press it a few times to keep going back. See if that works for you
Another solution for your problem is to use the hotkey to "Send table to bottom". This will move the top table to the bottom of the stack, allowing you to see the previous table. You can press it a few times to keep going back. See if that works for you
