06-11-2019, 05:56 AM
(06-09-2019, 11:58 AM)SaT_Admin Wrote:(06-09-2019, 03:41 AM)wuwu Wrote: I stack my tables. If I stack 5 or less tables, SaT works well. If I add a 6th table or more, then a glitch starts to occur. The glitch: after I press a hotkey, the hotkey takes it's action and then another table will blip up and then disappear into the stack (this does not cause me to misclick, but my hands per hour is significantly lower than it should be).
One other person also reported this problem. From what I can tell, the new WPN software does not respect the setting within its client to "Auto Switch between tables":
http://www.stackandtile.com/sat/wpnoptions.png
This is supposed to be WPNs setting to cause the tables to pop up when action is required or not. I tested that option on and off, and sometimes WPN would still bring tables to the top, even when that setting was turned off (with SaT completely off as well). So, if that setting isn't working, then that would mean both SaT and WPN are both trying to bring tables to the top, which would cause that conflict.
Can you test that setting for yourself and see if it works properly or not?
If it fails for you too, then the problem is with WPN and we need to contact them until they fix it
The "Auto Switch between tables" setting is broken on my end (it stays on, even if I turn it off). However, why would SaT work perfectly fine until I add the 6th table? Seems like the issue might be with SaT, or with the "auto switch between tables," or a combination of the two..... I am no programmer so I would hold your word much stronger than mine after you weigh in on this. Thoughts?