Hello,
I'm on latest version, and tonight I've had 5-6 times already some Winamax tables sitting out.
Tables were left in the stack, and I have to rely on audio cues, and checking all tables every once in a while to make sure I don't autofold.
I haven't played poker in a few months, just came back to SaT tonight, so I couldn't say if this is very new or not.
I've seen a sit out when I was folded to, and also vs RFI, so this is not in a specific situation.
Best regards
Posts: 5,921
Threads: 31
Joined: Apr 2011
Can you try Removing and re-Including the site, and then do some tests with a single table and see if you notice any failures?
So far so good, no issues after re-adding the site, thanks!
Hi, after a few days I get a somewhat different problem.
I often hear the Winamax 'hurry up' sound, but this time clicking on the Winamax icon in the Windows taskbar is enough to make the table appear.
Posts: 5,921
Threads: 31
Joined: Apr 2011
Hmmmm what other sites are you playing when this happens? Do you always notice another specific site at the top when this problem occurs?
I'd run Help->Show Testing Info, and test with one table at a time, make sure the ACTION REQUIRED line changes from NO to YES when its your turn to act, and then changes back to NO after youve taken your action
Then test with one table for the next site, etc, and check again
If SAT mistakenly thinks that another site ALWAYS requires action, then it won't allow Winamax (or other sites too) to pop over the top because it thinks you haven't finished your action.
If you find another site always says ACTION REQUIRED = YES, and never changes, then you would try Removing and re-Including that particular site and then re-test
>what other sites are you playing when this happens
Stars and Winamax.
I've played a bit with 1 table of each, and ACTION REQUIRED behaved as expected. I'll record next sessions, and note timestamps when I see the behavior occurring.
It might help finding a pattern.
Posts: 5,921
Threads: 31
Joined: Apr 2011
It only happened twice yesterday, here are some details:
Both times, clicking on the Winamax toolbar icon brought two tables. first at half time bank, the second with almost a full time bank (~14s out of 15).
It takes two seconds for the time bank to start running, so it doesn't seem to be a coincidence. I think this issue blocks all Winamax tables.
Both blocked table situations were different:
- SB v MP RFI, with two tables already tiled (PS / Wina)
- BTN RFI, with one Wina table tiled.
I'll continue recording the sessions to try to pin it down.
Posts: 5,921
Threads: 31
Joined: Apr 2011
What I'm curious is, the times when this happens, is a Stars table the current active table?
Also, what Play Mode are you using in SAT?
>Also, what Play Mode are you using in SAT?
Don't really know what this means, but I have two layouts, for <= 6 tables, and a stack and tile one for more.
The issue arises when I use the latter.
>when this happens, is a Stars table the current active table?
Not necessarily, I've had it happen 8 times tonight, and once it was the very first hand of a Winamax tournament, which started when all other tables were still on break.
I will review the footage tomorrow, even though I don't think I'll find a convincing pattern.
If you could provide a custom version that writes a log each time a table becomes active, with the timestamp, that might help
