Table always on the grid - Printable Version +- StackAndTile Forums (https://www.stackandtile.com/forum) +-- Forum: General (https://www.stackandtile.com/forum/forumdisplay.php?fid=1) +--- Forum: Support Help (https://www.stackandtile.com/forum/forumdisplay.php?fid=2) +--- Thread: Table always on the grid (/showthread.php?tid=2010) |
Table always on the grid - mouggyy - 08-13-2019 Hi, i just want to test SaT. I launch a bunch of table on ps.eu / ps.com / winamax and party.fr But table keep stay on the grid and not come on the 1st slot which is the stack slot. i don't understand why I configure Sat like this with this .ini: Code: [settings] RE: Table always on the grid - SaT_Admin - 08-13-2019 Thanks for posting your layout config file, that helps a lot. Looking at it shows that SaT isn't scanning the tables properly. My first guess would be that you're using multiple monitors, and/or monitors with very high resolution and therefore you're using a high scaling % within Windows. If so, I suggest you first check this page and try solutions #1 and maybe #2: https://www.stackandtile.com/sat/help/windows-10-fix And then Remove and re-Include all of the sites and then try again and see if it works RE: Table always on the grid - mouggyy - 08-14-2019 I use a monoitor and a windows scaling of 125%. I test 100%, 150% on the laptop and the monitor but doesn't work. I test without the monitor with only the laptop, doesn't work. When i click on show testing info : Actions required is always on yes and it's why table go always on the grid slot and not on the stack slot. I don't know why it doesn't work RE: Table always on the grid - SaT_Admin - 08-14-2019 Did you try doing solution #1 from that link? Please try that. You don't set each monitor scaling individually. You need to specifically click "Advanced Scaling Settings", and then set the Custom Scaling value where you type the % into the text box. Windows will then ask you to log out. Then Remove your sites from SaT and re-Include them, and run the Testing Info again RE: Table always on the grid - mouggyy - 08-14-2019 It's work. Thank you for you time and for your help. I don't type the scaling value on the text box and just set with the menu. RE: Table always on the grid - SaT_Admin - 08-15-2019 Ok good.. Usually setting the scaling in the drop down menu doesn't work. That's why I suggest using the Custom Scaling and typing it in the text box. If you notice it failing again, try that. |