12-20-2014, 03:15 AM
(12-20-2014, 02:39 AM)Quechecker Wrote: Thx for fast response and spot on advice.
Yes i did chose the new config. Usually i run both programs as non admin but sometimes i might run SaT as admin. This time i run both programs as admin
Also i redid new site setup one more time. Same result. But i made another profile with base click checked. F10 still wouldnt fold on include site but this time stack and tile mode did work.
This is strange and to be honest I wouldn't rely on it. During Include Site setup, SaT tries to click at the coordinate location on the table that was specified during the custom site wizard. I don't know whats going on, if it worked during the wizard (especially with basic click) then it should work during Include Site.
Run the Test described here just to be sure:
http://www.stackandtile.com/sat/help/tab...stay-stack
Quote:But it would lag on more than 7 tables. Tables would blink upon clickin fold button and some tables would not stack back to slot 1. Overall pretty chaotic. I never experienced that on titanpoker where at one point i may be running 15 tables or so.
Any advice on the last issue?
Not sure. It could probably be something related to the other issue. Are you using DWM scan mode in Advanced Options?
