setting up party poker - Printable Version +- StackAndTile Forums (https://www.stackandtile.com/forum) +-- Forum: General (https://www.stackandtile.com/forum/forumdisplay.php?fid=1) +--- Forum: Support Help (https://www.stackandtile.com/forum/forumdisplay.php?fid=2) +--- Thread: setting up party poker (/showthread.php?tid=1852) Pages:
1
2
|
setting up party poker - Hacksaw Hal - 02-24-2018 hi i downloaded the trial and i have set up pokerstars and ladbrokes(i poker) seemingly ok. however i can't get party poker past the press F10 to fold stage- it just doesn't happen. i have changed the poker client software settings as in your guide so i'd appreciate some help to get it sorted thanks RE: setting up party poker - vitinhodzi - 02-24-2018 I am having the same issue. RE: setting up party poker - SaT_Admin - 02-24-2018 PartyPoker put out an update yesterday which broke SaT. Other users reported it just a few threads down. Download this version v2.95n http://www.stackandtile.com/sat/tmp/StackAndTile_Setup-295n.exe Make sure that you have 3 color action buttons enabled, as described on the PartyPoker help page: http://www.stackandtile.com/sat/help/partypoker Then Remove and re-Include PartyPokerModern and let me know how it goes. If you notice any problems, please come back and tell me. RE: setting up party poker - vitinhodzi - 02-24-2018 Fixed with the last version! TY RE: setting up party poker - Hacksaw Hal - 02-24-2018 thanks seems to be ok now i started new thread because i wasn't sure if this was a purely setup problem or not RE: setting up party poker - SaT_Admin - 02-24-2018 its all good.. let me know if you notice anything that doesn't work RE: setting up party poker - Hacksaw Hal - 02-27-2018 hi i now have a problem on pokerstars where the tables do not stack. it still works on the very first 4 table configuration i made but not on 6 table configurations although it did before. i tried creating a new one but that didn't work either RE: setting up party poker - Hacksaw Hal - 02-27-2018 the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396? RE: setting up party poker - SaT_Admin - 02-27-2018 (02-27-2018, 01:19 AM)Hacksaw Hal Wrote: hi (02-27-2018, 01:35 AM)Hacksaw Hal Wrote: the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396? I would think it should work at that table size. But the problem is that SaT is not detecting when it is your turn to act. There can be a few different reasons for this. I'd run this Test and maybe try Removing and re-Including the site: http://www.stackandtile.com/sat/help/tables-will-not-stay-stack-tables-pop-incorrectly Worst case is you can try creating a File->New Layout, and resizing a Stars table with your mouse slightly larger than 536x396, and then pressing F7 during the New Layout wizard. And then see if it works in this new layout with a slightly larger slot size RE: setting up party poker - Hacksaw Hal - 02-27-2018 thanks. everything working ok again now |