hi
i downloaded the trial and i have set up pokerstars and ladbrokes(i poker) seemingly ok. however i can't get party poker past the press F10 to fold stage- it just doesn't happen. i have changed the poker client software settings as in your guide so i'd appreciate some help to get it sorted
thanks
I am having the same issue.
Posts: 5,771
Threads: 30
Joined: Apr 2011
02-24-2018, 05:38 AM
(This post was last modified: 02-25-2018, 08:02 AM by SaT_Admin.)
PartyPoker put out an update yesterday which broke SaT. Other users reported it just a few threads down.
Download this version
v2.95n
http://www.stackandtile.com/sat/tmp/Stac...p-295n.exe
Make sure that you have 3 color action buttons enabled, as described on the PartyPoker help page:
http://www.stackandtile.com/sat/help/partypoker
Then Remove and re-Include PartyPokerModern and let me know how it goes. If you notice any problems, please come back and tell me.
Fixed with the last version!
TY
thanks seems to be ok now
i started new thread because i wasn't sure if this was a purely setup problem or not
Posts: 5,771
Threads: 30
Joined: Apr 2011
its all good.. let me know if you notice anything that doesn't work
hi
i now have a problem on pokerstars where the tables do not stack. it still works on the very first 4 table configuration i made but not on 6 table configurations although it did before. i tried creating a new one but that didn't work either
the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396?
Posts: 5,771
Threads: 30
Joined: Apr 2011
(02-27-2018, 01:19 AM)Hacksaw Hal Wrote: hi
i now have a problem on pokerstars where the tables do not stack. it still works on the very first 4 table configuration i made but not on 6 table configurations although it did before. i tried creating a new one but that didn't work either
(02-27-2018, 01:35 AM)Hacksaw Hal Wrote: the problem seems to be the size of the tables i configured for pokerstars- they are configured 536 x 396. it does stack the table but immediately bounces it back to the grid. it works on larger sizes but not this. should it be working on 536 x 396?
I would think it should work at that table size. But the problem is that SaT is not detecting when it is your turn to act. There can be a few different reasons for this. I'd run this Test and maybe try Removing and re-Including the site:
http://www.stackandtile.com/sat/help/tab...ncorrectly
Worst case is you can try creating a File->New Layout, and resizing a Stars table
with your mouse slightly larger than 536x396, and then pressing F7 during the New Layout wizard. And then see if it works in this new layout with a slightly larger slot size
thanks. everything working ok again now
