01-10-2013, 11:44 AM
(01-10-2013, 10:46 AM)Guest Wrote:(01-10-2013, 10:39 AM)Guest Wrote: just noticed "activate_most_urgent=0" if i make this "1" will the windows pop up in highlighted in the order i need to act?actually i have this clicked and it was a prob thats why i unticked it.
Not sure what you mean. Why did you uncheck it? Its the first setting in the Advanced Options menu.
(01-10-2013, 10:38 AM)Guest Wrote: Anyway my problem is (when im on BCP)u can see from my config i have 12 slots and use the S&T function w/VPIP.When i play a hand it will bring the table out to the next avail slot and do this for each table i VPIP.Problem is sometimes EVEN AFTER it will stay in the grid(same slot it was in) and sometimes it will go back to the stack.
Sometimes will stay in the grid 'even after' what?
Quote:ALSO sometimes if i time down and sit out by mistake its impossible to get to the table to sit back in without disabling the program beacause i play so many tables theres always an active one.
SaT will not force a table to be active if you try to change focus. For example, if some table requires action, and SaT activates it (if the setting is on), and then later you click away to another table, SaT will not force activation again until you've acted somewhere.
Quote:BIG problem for me though when the hand ends and stays in the slot because i overlap 4 spots and need to clear out the unused spot asap so i can see all thats going on.
Are you sure that End Of Hand detection is working properly? Are you using preferred seating?
Would using a 'Stack Table' hotkey be sufficient to clear a table?
