Tables not cycling to front
#7
Ok. Too many things going on at once. We need to tackle your problems one by one.

(02-27-2014, 07:38 AM)biscuithead Wrote: I was using novagray so the buttons were the same color. I switched to classic view and it was working ok except the tables wouldnt pop up unless i had the pokerstars option checked to pop up when required.

Make sure you're using Classic theme on your tables, and then also within SaT, make sure the only pokerstars site you have included is "PokerStarsClassic"

Leave the PokerStars option off. Make sure the first box is checked in SaT's Advanced Options.

Then run the above Test again.

Quote: But when the table poped up the action wouldnt move to that table until i clicked the table. The action was on another table in the stack that i couldnt see and thats where the hotkeys were going.

You mean SaT's hotkeys? In Advanced Options, on the Hotkey tab, you probably have chosen to send the hotkeys to the active table instead of the table under the mouse.

Quote: Also, the tables don't move back to the stack from the grid after the hand is over. They just stay there.

They only do this if you've turned the two options on in Advaned Options to "Stack table at End of Hand" and "Include Hole card detection"
Reply


[-]
Quick Reply
Message
Type your reply to this message here.

Username::
Image Verification
Please enter the text contained within the image into the text box below it. This process is used to prevent automated spam bots.
Image Verification
(case insensitive)
Please select the number: 6
1 2 3 4 5 6 7 8 9 10

Messages In This Thread
Tables not cycling to front - by biscuithead - 02-25-2014, 11:13 AM
RE: Tables not cycling to front - by biscuithead - 02-25-2014, 11:23 AM
RE: Tables not cycling to front - by SaT_Admin - 02-25-2014, 12:35 PM
RE: Tables not cycling to front - by biscuithead - 02-26-2014, 05:14 AM
RE: Tables not cycling to front - by SaT_Admin - 02-27-2014, 12:22 AM
RE: Tables not cycling to front - by biscuithead - 02-27-2014, 07:38 AM
RE: Tables not cycling to front - by SaT_Admin - 02-27-2014, 10:17 AM