11-16-2011, 05:34 PM
I have been trying to get SAT running for a couple hours now, and i'm still doing something wrong. I read all the beginner info in the help section, and followed the set-up instructions exactly. I was able to set up my grid/slots very easily, and was able to add Merge to my poker site list. I was able to press F7 to get SAT to recognize the table, and was able to press F10 to get a fold.
Everything seemed fine to this point, until I actually tried to test it out. I loaded up a few tables, and nothing happened (yes I remembered to press start
). The tables do not move at all. They do not move to the stack, and they do not move to any of the slots when action is required.
Hotkeys are also unresponsive. I tried different ones like "fold" and "stack table" and had no luck. It seems like the program isn't communicating with Merge correctly, and I can't figure out why. This really confused me, because like I said, I was able to use the fold hotkey when adding Merge to the site list.
Does anyone have any suggestions for what the problem might be? FWIW I made sure to run the program as admin, and made sure to hit "start" on SAT before opening any tables. I assume there is some simple setting i've gotten wrong when setting it up lol.
Thanks in advance!
Everything seemed fine to this point, until I actually tried to test it out. I loaded up a few tables, and nothing happened (yes I remembered to press start
). The tables do not move at all. They do not move to the stack, and they do not move to any of the slots when action is required.Hotkeys are also unresponsive. I tried different ones like "fold" and "stack table" and had no luck. It seems like the program isn't communicating with Merge correctly, and I can't figure out why. This really confused me, because like I said, I was able to use the fold hotkey when adding Merge to the site list.
Does anyone have any suggestions for what the problem might be? FWIW I made sure to run the program as admin, and made sure to hit "start" on SAT before opening any tables. I assume there is some simple setting i've gotten wrong when setting it up lol.
Thanks in advance!
