11-17-2011, 04:23 AM
Ok, here is what SHOULD happen, based on your config:
When you press Start, tables should start filling up your grid slots 2, 3, and 4 (this is the New Tables=grid setting). Then, you only have one hotkey set up, Z, so you can mouseover each table and press Z, and the tables should return to the stack. Then, once they are in the stack, when it is your turn to act, they should start filling the grid again.
However, if you say that SaT is unresponsive and none of the above works, then there is a major problem. I would suggest running SaT as admin, but you've already done that too. If its still not working, send me a PM with your skype name and I'll take a look.
When you press Start, tables should start filling up your grid slots 2, 3, and 4 (this is the New Tables=grid setting). Then, you only have one hotkey set up, Z, so you can mouseover each table and press Z, and the tables should return to the stack. Then, once they are in the stack, when it is your turn to act, they should start filling the grid again.
However, if you say that SaT is unresponsive and none of the above works, then there is a major problem. I would suggest running SaT as admin, but you've already done that too. If its still not working, send me a PM with your skype name and I'll take a look.
